Categories

Hot Products

News

Carving Style Of Upper Laser Engraving Machine
Jul 15, 2017

              Dot-matrix engraving resembles high definition of dot-matrix printing. The laser head swings around each time, carving out a line composed of a series of points, and then the laser head moving up and down to carve out many lines, and finally constitute the entire version of the image or text. Scanned graphics, text and vectorization can be carved using dot matrix.

               Vector cutting is different from dot-matrix engraving, and vector cutting is done on the contour line. We usually use this mode to cut through the wood, the gram grain, the paper and so on material, also may carry on the marking operation on many kinds of material surface.The performance of a carving machine, mainly by carving speed, engraving strength and the size of the spot.Laser Engraving Machine

             Engraving speed refers to the speed at which a laser head moves, usually in IPs (in inches/sec), with high speeds that bring high productivity. Speed is also used to control the depth of the cutting, and for a particular laser intensity, the slower the speed, the greater the depth of cutting or engraving. You can use the Engraving machine panel to adjust the speed, you can also use the computer's print driver to adjust. Within 1% to 100%, the adjustment range is 1%. Hummer's Advanced motion control system allows you to sculpt in high speed, still get super fine carving quality.Laser Engraving Machine

             Engraving strength refers to the intensity of the laser on the surface of the material. For a particular engraving speed, the greater the intensity, the greater the depth of cutting or carving. You can use the Engraving machine panel to adjust the strength, you can also use the computer's print driver to adjust. Within 1% to 100%, the adjustment range is 1%. The greater the intensity, the greater the speed. The deeper the depth of the cut.

             The beam spot size can be adjusted by using lenses of different focal lengths. The lens of the spot is used for high-resolution engraving. Large-spot lenses are used for lower-resolution engraving, but for vector cutting, it is the best choice. The standard configuration of the new equipment is a 2.0-inch lens. The spot size is in the middle, suitable for various occasions.Laser Engraving Machine


  • QR CODE
  • facebook